Removing Carpet

- You’ll need a few things--heavy duty trash bags, protective gloves, sharp utility knife, dust mask, and a crowbar, and for removing padding glue or staples, a flat floor scraper or padding adhesive remover. 

- Remove all the furniture from the room, as well as floor vents, and any under shoe molding.  Vacuum very well to remove as much dirt and dust as possible. 

- If there is a room door that swings inward, take the door off the hinges to keep it out of the way. 

- Suit up with the dust mask and the work gloves, and start in a corner, pulling a section back with the crowbar, taking care to be mindful of the tack strips that can be holding down the carpet around the perimeter of the room. 

- Once you’ve pulled the carpet back, fold it over, and, using the utility knife, cut a section of carpet from the back side for easier going. (Cutting the large rug into sections makes it much more manageable than rolling up the whole piece.)  

- Remove the tack strips with the crowbar if you have hardwood floors under the padding that you plan on refinishing.  Start in the middle of the strip, loosening the nails, and work towards the ends. 

- After the tack strips are out, tackle the padding.  Pull it up, cutting into sections the same way the carpet was cut. 

- Some padding is installed with adhesive, and some is stapled to the floor.  If there is glue remaining on the floor, follow the instructions on the carpet padding adhesive remover to get the glue off the flooring. The staples can be removed with the floor scraper. 

- Remember that if you’re planning on recarpeting the floor, leave the tack strips in place, and remove the padding anyway, as most installers require new padding to be put down.